Alen T300 Bedienungsanleitung PDF herunterladen (Seite 8)

www.AlenCorp.com 1-800-630-2396

To sign up and save just visit AlenCorp.com/lters or call 1-800-630-2396.



1. Before replacing the UV light, please unplug the unit.

2. Lay the unit on its side and remove the screws of the UV light compartment under the base

of the unit.

3. Remove the screw that is holding the wire harness.

4. Use one or two at tip screw drivers to depress the clip on each side of the UV light holder.

5. Remove the old UV light and insert the UV light into the unit, making sure not to touch the

glass part of the bulb with you bare ngers as it can lower the life of the bulb.

1. Push down the lter cover tab and lift the lter cover off.

3. Take the new lter out of the plastic bag; distinguish the

front side from the back side of the lter. The front side

has the black foam layer, known as the pre-lter, which

should be facing out when inside the unit, insert into the

air cleaner with the arrow pointing inward.

2. Pull out each used lter; the T300 has two lters that

should be replaced at the same time.

4. Insert the bottom of the lter cover rst and then snap in

the upper part of the grill.

5. RESET the lter

indicator by holding

down RESET while the

unit is ON until the

illuminated bars disap

pear. To reach the but

ton, use a pin or

extended paperclip.



1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Alen T300 Bedienungsanleitung Seite 8